Configuring a PPP Connection

The following table outlines the steps for configuring a PPP connection in Windows 200X:

Configuring a PPP Connection

   1.

Right-click Network Neighborhood and select Properties.

This image illustrates configuring a PPP connection.

2.

Double-click New Connection Wizard.

This image illustrates configuring a PPP connection.

3.

Click Next.

This image illustrates configuring a PPP connection.

4.

Select Set up an Advanced Connection and click Next.

This image illustrates configuring a PPP connection.

5.

Select Connect directly to another computer and click Next.

This image illustrates configuring a PPP connection.

6.

Select Guest and click Next.

This image illustrates configuring a PPP connection.

7.

Type in a connection name and click Next.

This image illustrates configuring a PPP connection.

8.

Choose the COM port your null modem cable is connected to and click Next.

This image illustrates configuring a PPP connection.

9.

Select My use only and click Next.

This image illustrates configuring a PPP connection.

10.

If you would like, select to add a shortcut to the desktop and click Finish.

This image illustrates configuring a PPP connection.

11.

At the log-in prompt, select Properties.

This image illustrates configuring a PPP connection.

12.

On the General tab, select Configure.

This image illustrates configuring a PPP connection.

13.

Configure the settings shown below and click OK.

This image illustrates configuring a PPP connection.

14.

Select the Networking tab, select PPP from the pull-down menu and only leave TCP/IP for the protocol type selected and click OK.

This image illustrates configuring a PPP connection.

15.

Enter the username of clariion and a password of clariion! and click Connect.

This image illustrates configuring a PPP connection.

16.

Wait for the logon credentials to be authenticated and you are connected.

This image illustrates configuring a PPP connection.

 

 

 

 

 

 

 

 

 

SP Setup Pages

The following table outlines the steps for assigning IP addresses to the SPs using the setup page:

Assigning IP Addresses Using the SP Setup Pages

   1.

Open a web browser and connect to http://192.168.1.1/setup.

This image represents setting the IP addresses on the SPs.

2.

Enter all Networking information and click Apply Settings.

A NOTE indicates important information that helps you make better use of your computer.

NOTE:
Clicking Apply Settings will reboot the storage processor.

This image represents setting the IP addresses on the SPs.

3.

Establish a PPP connection to SPB. Open a web browser and connect to http://192.168.1.1/setup.

This image represents setting the IP addresses on the SPs.

4.

Enter all Networking information and click Apply Settings.

A NOTE indicates important information that helps you make better use of your computer.

NOTE:
Clicking Apply Settings will reboot the storage processor.

This image represents setting the IP addresses on the SPs.

 

 

 

 

 

 

Follow Us
Follow us on Twitter Follow Us On Orkut Google Groups Follow us on LinkedinFollow us on Youtube Follow us on Facebook

 

 

About Us | Site Map | Privacy Policy | Contact Us | Disclaimer

Best Viewed on 1024*768 Resolution